Installed in a DWV piping drainage system to provide waste water backflow protection to fixtures and floor drains, below the flood plane. Provided with a rubber o-ring, and cap.
Injection molded in non-toxic durable white polyvinyl chloride (PVC) | Maximum service temperature rated at (140F) +60C | Comes complete with o-ring, | Can be buried up to 16" when used with a Canplas backwater valve sleeve Kit | Hand tighten lid plus a half turn provides a complete seal | Normally used in the drainage portion of the DWV System only | Use approved PVC primer and solvent cement to make PVC Jo ints | Flame retardant, will not support combustion in the presence of an ignition source | Maximum Service Temperature Rated at (140F) +60C | Use approved PVC primer and solvent cement to make PVC Joints | Normally used in the drainage portion of the DWV system only | Flame Retardant, will not support combustion in the presence of an ignition source
Manufacturer Web Site: https://canplas.com/ | Manufacturer Web Site: http://www.canplas.com
Your Dynamic Snippet will be displayed here... This message is displayed because you did not provided both a filter and a template to use.